Crushing and Screening Plant Automation System;
Systems that integrate and control all tasks performed by both human labor and machines under a single structure are called automation. These systems offer more efficient and cost-effective operation, while enabling facilities to reach global production standards. Automation is highly critical in Crushing and Screening Plants. To achieve high-quality output, automation systems must be implemented and monitored. As a result of automation, production efficiency increases while operational costs decrease.
To prevent sudden load on the transformer or generator, crushers in the plant are started sequentially based on their motor power ratings. After that, the rest of the plant begins operation in reverse order (from end to start) based on predefined parametric time settings.
When the stop command is issued, the feeders are stopped first. Then, belts, screens, and crushers are stopped in reverse order of operation, again based on time parameters. Crushers are allowed to run idle until they reach a no-load current level before shutting down.
The operation of one motor is dependent on the motor preceding it. If a motor stops for any reason, all linked downstream motors are also stopped. Crushers, however, are only stopped due to their own faults (such as overcurrent or low oil pressure). This prevents unnecessary start-stop cycles for crushers due to minor issues. Once the fault is resolved, stopped motors can be restarted, and the plant resumes operation from where it left off.
Crusher current values are continuously monitored. Based on these values, the system intervenes with the feeder to prevent crusher overload, ensuring consistent and efficient operation of the plant at full capacity.
Maintenance time parameters are set for each crusher. When a crusher reaches its predefined operational duration, the operator is alerted for scheduled maintenance.
The plant’s operational status, faults, crusher current values, feeder speeds, belt load values, and crusher run-times can be monitored in real time via animated displays.
All motors are monitored for thermal protection. Belts are monitored with rope switches, misalignment sensors, and belt break detection. Crushers are monitored for current draw, lubrication, and hydraulic unit performance.
All faults are displayed on the fault screen (e.g., “Tertiary Crusher Discharge Conveyor Misaligned”). These faults are recorded in the system. Additionally, warnings such as “Cone Crusher Maintenance Due”, “Cone Crusher Overcurrent”, and “Primary Crusher Has Been Running Idle for 30 Minutes” are also logged and can be reported as needed.

EN
FR
TR


